Cisco SOHO 77 Hardware Installation Manual page 30

Installing the Router
Connecting a Server, PC, or Workstation
Before connecting a server, PC, or workstation to the router, see
to set the router TO HUB/TO PC button.
To connect a server, PC, or workstation to the router, follow the steps in
Figure 2-4
To verify the connection, check that the Ethernet 1 LED is on after you complete the router installation.
Cisco 827 and SOHO 77 Routers Hardware Installation Guide
2-10
Connecting a Server, PC, or Workstation to the Router
1. Set TO HUB/TO PC
button.
ETH ERN M od el Ci sco
TO HUB ET
TO PC CON SOL
E
ADS L
1
2. Connect yellow cable
to ETHERNET 4 port
on router.
PC
3. Connect other end of cable
to server, PC, or workstation.
Table 2-2 on page 2-7
1. Set TO HUB/TO PC
button.
Cisco 827, 827-4V
and SOHO 77
82 7-4 V
PHO NE
+5,+ 12,-1
2,-24 ,-71
VDC
4
3
2
1
2. Connect yellow cable
Chapter 2 Installation
to determine how
Figure 2-4 on page 2-10.
Cisco 827H and
SOHO 77H
TO HUB
ETH ERN
TO PC ET 10BA SET Ci sco 82 7
H
CON SOL
E
4 ADS L
+5 VDC
3
2
1
to ETHERNET 4 port
on router.
78-6854-03