User Manual
GFK-2883F
3.1.5
Panel Mounting
For applications requiring maximum or long-term resistance to mechanical vibration and
shock, the panel-mounting method is strongly recommended. A minimum panel thickness
of 2.4 mm (.093 in) is required.
Figure 9: Panel Mount
The mounting diagram shown in Figure 9 applies to both the CEP001 Carrier and CEE001
Expansion Carrier.
Note
3.1.6
Installing a RX3i CEE Expansion Carrier
•
Installation & Mounting
:
•
Tolerances on all dimensions are ±0.2mm (0.078 inch) non-cumulative.
•
Apply 1.1 to 1.4 Nm (10 to 12 in/lbs) of torque to M3.5 (#6-32) steel screws threaded into
tapped holes in the panel.
To install a RX3i CEE Expansion Carrier
1.
Open the connector cap on the RX3i CEP Carrier.
2.
Slide and install the CEE Expansion Carrier along the guide slots on the CEP
Carrier.
3.
When the Expansion Carrier is aligned with the CEP Carrier, engage the
expansion connectors.
4.
Close the connector cap.
5.
Secure the Expansion Carrier to the DIN-rail or panel. Refer to the procedure,
Installing an RX3i CEP Carrier on a DIN-rail, or Panel Mounting.
Chapter 3
Sep 2019
21