Wac5302D-S - ZyXEL Communications NWA Series User Manual

Table 18 WAC6103D-I LEDs (continued)
LED
Management
WLAN
WLAN
UPLINK
LAN
Locator

3.4.5 WAC5302D-S

The LEDs automatically turn off when the WAC5302D-S is ready. You can press the LED ON button for one
second to turn on the LEDs again. The LEDs will blink and turn off after two minutes.
Chapter 3 Hardware
COLOR STATUS
Green On
Slow Blinking (Blink for 3
times, Off for 3s)
Slow Blinking (On for 1s,
Off for 1s)
Off
Amber Blinks between amber
and green alternately
Green
(1 second interval).
Amber Blinks between amber
and green alternately 3
Green
times and then turns
solid green for 3
seconds.
Green On
Amber On
Off
Green On
Amber On
Off
Amber On
Blinking
Green On
Blinking
Off
Amber On
Blinking
Green On
Blinking
Off
White Blinking
Off
NWA/WAC/WAX Series User's Guide
DESCRIPTION
The Zyxel Device is managed by an AC or the NCC.
The Zyxel Device is searching (discovery) for an AC.
The Zyxel Device is using default WiFi settings, or the Zyxel
Device is connected to the NCC but is unregistered with
the NCC.
The Zyxel Device is in standalone mode.
The Zyxel Device is searching (discovery) for the NCC.
The NCC is connecting to the registered Zyxel Device.
The 2.4 GHz radio is set to "Ceiling" and is active
The 2.4 GHz radio is set to "Wall" and is active
The 2.4 GHz WLAN is not active.
The 5 GHz radio is set to "Ceiling" and is active
The 5 GHz radio is set to "Wall" and is active
The 5 GHz WLAN is not active.
The port is operating as a 100 Mbps connection.
The Zyxel Device is sending/receiving data through the
port at 100 Mbps.
The port is operating as a Gigabit connection (1000
Mbps).
The Zyxel Device is sending/receiving data through the
port at 1 Gbps.
The port is not connected.
The port is operating as a 100 Mbps connection.
The LAN port is sending/receiving data through the port
at 100 Mbps.
The port is operating as a Gigabit connection (1000
Mbps).
The LAN port is sending/receiving data through the port
at 1 Gbps.
The LAN port is not connected.
The Locator is activated and will blink to show the actual
location of the Zyxel Device between several devices in
the network.
The Locator function is off.
58