ZyXEL Communications NWA Series User Manual page 164

Table 64 Configuration > Object > AP Profile > SSID > Security List > Add/Edit Security Profile> Security
Mode: wep (continued)
LABEL
Authentication Settings
Enterprise
ReAuthentication
Timer
Authentication Type
Key Length
Key 1~4
Advance
Note: Click on the Show Advanced Settings button to show the fields describe below.
Idle timeout
Radius Settings
Primary / Secondary
Radius Server Activate
Radius Server IP
Address
Radius Server Port
Radius Server Secret
Primary / Secondary
Accounting Server
Activate
Accounting Server
IP Address
Accounting Server
Port
Accounting Share
Secret
Accounting Interim
Update
Chapter 13 AP Profile
DESCRIPTION
Select this to enable 802.1X secure authentication with a RADIUS server.
Enter the interval (in seconds) between authentication requests. Enter a 0 for unlimited
time.
Select a WEP authentication method. Choices are Open or Share key.
Select the bit-length of the encryption key to be used in WEP connections.
If you select WEP-64:
• Enter 10 hexadecimal digits in the range of "A-F", "a-f" and "0-9" (for example,
0x11AA22BB33) for each Key used.
or
• Enter 5 ASCII characters (case sensitive) ranging from "a-z", "A-Z" and "0-9" (for
example, MyKey) for each Key used.
If you select WEP-128:
• Enter 26 hexadecimal digits in the range of "A-F", "a-f" and "0-9" (for example,
0x00112233445566778899AABBCC) for each Key used.
or
• Enter 13 ASCII characters (case sensitive) ranging from "a-z", "A-Z" and "0-9" (for
example, MyKey12345678) for each Key used.
Based on your Key Length selection, enter the appropriate length hexadecimal or ASCII
key.
Enter the idle interval (in seconds) that a client can be idle before authentication is
discontinued.
Select this to have the Zyxel Device use the specified RADIUS server.
Enter the IP address of the RADIUS server to be used for authentication.
Enter the port number of the RADIUS server to be used for authentication.
Enter the shared secret password of the RADIUS server to be used for authentication.
Select the check box to enable user accounting through an external authentication
server.
Enter the IP address of the external accounting server in dotted decimal notation.
Enter the port number of the external accounting server. The default port number is 1813.
You need not change this value unless your network administrator instructs you to do so
with additional information.
Enter a password (up to 128 alphanumeric characters) as the key to be shared between
the external accounting server and the Zyxel Device. The key must be the same on the
external accounting server and your Zyxel Device. The key is not sent over the network.
This field is available only when you enable user accounting through an external
authentication server.
Select this to have the Zyxel Device send subscriber status updates to the accounting
server at the interval you specify.
NWA/WAC/WAX Series User's Guide
164