Installing The Slide Rails Into A Rack With Square Holes - Cisco Physical Access 1125 Appliance User Manual

Rack Mounting the Cisco PAM 1125 Appliance
Figure 3-14

Installing the Slide Rails into a Rack with Square Holes

If you mount the slide rail in holes that are not vertically aligned from front to back, you can damage the
Caution
slide rail and your mounting may not be secure.
To install the slide rails into the rack, perform the following procedure:
Step 1 At all four rack uprights, determine the vertical position in the rack where the slide rails are to be
installed. The top-most mounting hole for a particular Rack Unit (RU) mounting position is typically
identified by a mark or hole (see
Figure 3-15
1 RU 1 RU
1 RU 1 RU
Noting the holes that you determined in Step 1, align the left slide rail with its mounting holes.
Step 2
Cisco Physical Access 1125 Appliance User Guide
3-16
Locking the Adapter into Place
Figure 3-15 on page
Mounting Position Marks on a Rack
Chapter 3 Rack Mounting the Cisco PAM 1125 Appliance
3-16).
OL-20929-01