Replace The Outdoor Fan 12K - Friedrich VRP Series Service & Parts Manual

Replace the Outdoor Fan 12k

Caution: Wait for 2 minutes after removing power from the unit to allow capacitors to discharge
before handling the MCS board, disconnecting leads or connectors, or taking ohm readings.
1. Remove unit from closet.
2. Remove front, left and and right side access panels.
3. Unplug molex harness from cabinet junction (white 3 pin plug)
4. Remove nuts from fan motor mount at 4 places.
5. Remove 8 screws from fan inlet ring.
6. Fan assembly can be removed through the right side of the unit.
7. Remove fan blade from motor shaft.
8. Remove motor from mount.
9. Install new fan motor in reverse sequence.
Molex Connector
Mounting Bolts
(4 Places)
92
COMPONENT TESTING
Figure 606 (Outdoor Fan)