Friedrich VRP Series Service & Parts Manual page 58

Wall Controller Installation
Wall Controller Installation 12 & 24k
Electrical Installation Electrical Installation of the unit (Detail A) the side of the unit (Detail A) Remove and discard hole knock-out from the side Remove and discard hole knock-out from
l (Detail C, see below) Ppwer terminal block (Detail C, see below) Remove the electrical access panel to expose the incoming C B Remove the Electrical Access Panel (Detail B) to expose the Incoming Power Terminal Block
L1 Ground L2 L1 Ground L2 Insert all wires through the punched out hole and fasten Red to L2 Black to L1 Green to Ground punched out hole and fasten wires as follows: wires as follows: Insert all wires (Green, Black, Red) through the 26
Wiring to the VRP Unit
A. Strip the wire ends to 9/16" (15 mm).
B. Insert the wire pairs into terminals as shown below.
C. Insert ground shield wire into ground terminal (marked with a
ground symbol).
D. Tighten the screws to secure the wires to the corresponding
terminals.
E. Pull the wires to check that they are securely affixed to the
terminal block.
25
58
INSTALLATION
(Wall Controller Installation
FIGURE 417 )