Wind The Bobbin; Insert The Bobbin - Singer Elite CE677 Instruction Manual

Wind the Bobbin

A
B
1. Place the thread spool on the spool pin. Slide a spool cap firmly
against the spool.
2. Place the thread into the thread guide (A) from front to the
back. Bring the thread clockwise around the bobbin win-
ding tension disc, making sure that the thread is pulled
snuggly between the discs.
3. Thread through the hole in the bobbin (C) from the inside to
the outside.
4. Place the bobbin on the bobbin winding spindle. Make sure the
bobbin is pushed down firmly.
5. Push the bobbin winding spindle to the right. Hold the thread
end, and press the foot control to start winding.
Note: When the bobbin winding spindle is pushed to the right, the machine will not sew. Make sure to push the bobbin spindle back to
the sewing position (left) before sewing.

Insert the Bobbin

Note: Make sure that the needle is fully raised and the machine
is turned off before inserting or removing the bobbin.
1. Remove the bobbin cover (A) by pushing the small button to
the right of the cover (B) towards the right.
2. Insert the bobbin in the bobbin case with the thread running in
a counterclockwise direction.
3. With the tip of your finger on the bobbin, pull the thread slight-
ly to the right and under the guide (C) then towards the left.
Continue guiding the thread up toward the left and around
the curve (D). Bring it down the channel toward the front
and into the bobbin thread knife (E).
4. Replace the bobbin cover and pull the thread to the right to cut
off the excess thread.
After a few turns, take your foot off the foot control to
stop winding. Cut the excess thread tail above the bobbin,
making sure to trim it close to the bobbin. Step on the foot
control to resume winding. When the bobbin is full, the
bobbin winding will slow down and stop automatically.
Note: You can also start the winding by long pressing the
start/stop button.
When the winding spindle is pushed to the right, a bobbin
winding icon is shown on the display (D).
6. Push the bobbin winding spindle to the left. Remove the bobbin
and cut the thread.
1
A
B
3
C
5
E
C
D
2
4
D
Preparations – 11 Preparations – 11
English English