Table of Contents
Advertisement
TO REMOVE THE BOBBIN
Raise
take-up
lever
5, Fig.
8 to its
highest
point.
Draw
the
bed
slide
toward the left, in the bed of machine
Lift out bobbin with thumb and fore-
finger of left hand as shown in Fig. 10.
TO WIND THE BOBBIN
'
See Fig. 11
1. Place bobbin on spindle with pin of
spindle entering slot in right side of
bobbin.
2. Lock
bobbin
in place by pressing
bobbin
winder down
until latch
N,
Fig. 11 engages.
3. Hold hand wheel L and loosen large
knurled screw on hand wheel by turning
it over toward you.
Fig. 10. Removing Bobbin
4. Place spool of thread on spool pin 1.
Draw thread under and between tension
discs 2. Lead thread up through hole in
bobbin 3 from the inside.
5. Hold
end of thread
as shown
in
Fig. 11 and press controller as for sew-
ing. Continue
to hold end of thread
until it breaks off.
Advertisement
Table of Contents
