Wind The Bobbin; Insert The Bobbin - Singer M1155 Instruction Manual

Wind the Bobbin

B A
C
Machine from above
1. Pull up the spool pin to its full extent.
2. Place a thread spool on the spool pin.
3. Place the thread into the thread guide (A) from back to the
front. Make sure the threads slips into the spring (B). Bring
the thread clockwise around the bobbin winding tension
disc (C).
4. Thread through the hole in the bobbin (D) from the inside
to the outside.
5. Place the bobbin on the bobbin winding spindle. Make sure
the bobbin is pushed down firmly.
Note: When the bobbin winding spindle is pushed to the right, the machine will not sew. Make sure to push the bobbin spindle back to
the sewing position (left) before sewing.

Insert the Bobbin

Note: Make sure that the needle is fully raised and the machine
is turned off before inserting or removing the bobbin.
1. Remove the bobbin cover (A) by sliding it towards you.
2. Insert the bobbin in the bobbin case with the thread running
in a counterclockwise direction.
3. Pull the thread through the slit (B). Pull out about 15cm
(6 inches) of thread and place it to the back over the stitch
plate (C).
4. Attach the bobbin cover plate.
D
6. Push the bobbin winding spindle to the right. Hold the
thread end, and press the foot control to start winding.
After a few turns, take your foot off the foot control to
stop winding. Cut the excess thread tail above the bobbin,
making sure to trim it close to the bobbin. Step on the foot
control to resume winding. When the bobbin is full, the
bobbin winding will slow down.
7. Remove your foot from the foot control to stop winding.
8. Push the bobbin winding spindle to the left. Remove the
bobbin and cut the thread.
1
3
2
A
4
C
B
9
English