Wind The Bobbin; Insert The Bobbin - Singer SE9150 Instruction Manual

Wind the Bobbin

A
B
C
1. Place the thread spool on the spool pin. Slide a spool cap
firmly against the spool.
2. Pull the thread into the thread guide (A) from front to the
back and thread guide (B) from back to front.
3. Bring the thread around the bobbin winding tension disc
(C), making sure that the thread is pulled snuggly between
the discs.
4. Place the bobbin on the bobbin winding spindle. Make sure
the bobbin is pushed down firmly.
5. Bring the thread clockwise around the bobbin and place it
through the thread knife located under the bobbin winding
spindle (D).
Note: When the bobbin winding spindle is pushed to the right, the machine will not sew. Make sure to push the bobbin spindle back to
the sewing position (left) before sewing.

Insert the Bobbin

Note: Make sure that the needle is fully raised and the machine
is turned off before inserting or removing the bobbin.
1. Remove the bobbin cover (A) by pushing the small button
to the right of the cover (B) towards the right.
2. Insert the bobbin in the bobbin case with the thread running
in a counterclockwise direction.
3. With the tip of your finger on the bobbin, pull the thread
slightly to the right and under the guide (C) then towards
the left.
4. Continue guiding the thread up toward the left and around
the curve (D).
5. Bring it down the channel toward the front and into the
bobbin thread knife (E). Replace the bobbin cover and pull
the thread to the right to cut off the excess thread.
6. Push the bobbin winding spindle to the right. When the
winding spindle is pushed to the right, a bobbin winding
pop-up is shown on the display. Press the start button to
start winding.
7. Press the start/stop button to pause the winding if needed.
When the bobbin is full press the start/stop button
Note: You can also start the winding by using the foot
controller.
8. Push the bobbin winding spindle to the left. Remove the
bobbin and cut the thread by using the thread knife located
under the bobbin winding spindle (D).
1
A
3
C
5
E
D
2
B
4
D
Preparations – 1 7