HP Visualize c100 Install Manual page 5

Upgrade Instructions Overview
The general steps for performing the upgrade are outlined as follows and
should be performed in the sequence listed. Refer to the individual sections
of this guide for the actual step-by-step procedures for upgrading the C100/
110/C160/180 to a C200.
1 Update or arrange to have your operating system software updated to HP-UX
NOTE: You must back up your system before updating your operating system.
2 Determine and WRITE DOWN the LAN ID of your system. You will need to re-
3 Run the cclass_upgrade program
4 Power off the workstation and any peripherals and unplug the power cords. Dis-
5 Remove the main tray assembly
6 Remove the memory boards from the CPU board and the option boards from the
7 Remove the old power supply and replace it with the new power supply.
8 Place the new main tray assembly into the workstation chassis
9 Connect power cords and cables, restart the workstation, and enter the LAN ID
10.20. This can be a complex task and takes some time and planning.
enter it into the new system board
connect any peripheral cables and remove the floor stand
main tray and reinstall them onto the new main tray
when prompted
Upgrade Instructions Overview
3