HP Visualize c100 Install Manual page 29

9 Power on the system, monitor and any other peripherals.
NOTE: There will be a one to two minute delay, while the selftests complete, before any
monitor activity. Power saving monitors may shutdown into their power saving mode
during this time
10 If the monitor does not indicate the automatic monitor select process after two
11 To select that type press:
12 To save this monitor type enter:
13 The following appears on the screen:
NOTE: The built-in graphics is now configured. If you wish to use this configuration, go to
step 17. If not, stop the boot process as in step 14.
minutes, press:
TAB once
The system will then cycle through up to 15 types of monitors continually until
you see a message similar to the following clearly and legibly.
MONITOR INFORMATION
Path Slot
----------- ----
GRAPHICS(0) 0
Press [RETURN] to select this monitor type (type n of n
types).
ENTER
Y
If N is pressed, the monitor type will not be saved, but only used in this power-
on session. Any reboot or power cycle will revert to the original configuration
To select a new Graphics Monitor Type press the (TAB) key now
otherwise EXIT by entering any other key (or will timeout in
15 seconds)
Installing the New Main Tray Assembly
Head Type Size
---- ---- ----------
1 n nnnnxnnnn
Freq Class
---- -----
nnHz
27