HP Visualize c100 Install Manual page 26

Hp visualize c100: install guide

Hide thumbs Also See for Visualize c100:

Table of Contents

Installing the New Main Tray Assembly

Install the new C200 main tray assembly, as described in the following pro-

cedure:

1 Align the main tray assembly with the chassis and slide it into place, as shown in

Figure 16

2 Slide the main tray in until you feel it make contact with the internal connectors.

3 Push firmly and evenly on the main tray assembly to make sure that all connec-

4 Start all four thumb screws loosely, then tighten them firmly. See Figure 15.

NOTICE:

To maintain regulatory agency compliance, verify that the main tray is

fully seated and all four thumb screws are completely tightened.

Figure 15.

Thumb Screws

Installing the New Main Tray Assembly

tors are fully seated.

Thumb

Screws

Table of Contents