Roland SP-404MK2 Reference Manual page 112

Appendix
BUS 3, BUS 4
Parameter
Bypass, 303 VinylSim, 404 VinylSim, Cassette Sim, Lo-fi, Downer, Compressor,
Equalizer, Isolator, Super Filter, Filter+Drive, WrmSaturator, Overdrive, Distortion,
Crusher, Ring Mod, SBF, Resonator, Hyper-Reso, Chromatic PS, Reverb, Ha-Dou, Zan-
EFX TYPE Zou, Sync Delay, TimeCtrlDly, Ko-Da-Ma, Tape Echo, Chorus, JUNO Chorus, Flanger,
Phaser, Wah, Slicer, Tremolo/Pan, To-Gu-Ro, DJFX Looper, Scatter
DIRECT
Parameter
Filter+Drive, Resonator, Sync Delay, Isolator, DJFX Looper, Scatter, Downer, Ha-
Dou, Ko-Da-Ma, Zan-Zou, To-Gu-Ro, SBF, Stopper, Tape Echo, TimeCtrlDly, Super
Filter, WrmSaturator, 303 VinylSim, 404 VinylSim, Cassette Sim, Lo-fi, Reverb,
Direct FX1– Chorus, JUNO Chorus, Flanger, Phaser, Wah, Slicer, Tremolo/Pan, Chromatic PS,
Direct FX5 Hyper-Reso, Ring Mod, Crusher, Overdrive, Distortion, Equalizer, Compressor
OTHER
Parameter
This individually selects the bus to mute with MUTE BUS.
ALL
Mute Bus
BUS
Bypass, Auto Pitch (*), Vocoder (*), Gt Amp Sim (*), Harmony (*), Chorus,
JUNO Chorus, Reverb, TimeCtrlDly, Chromatic PS, Downer, WrmSaturator,
Input FX 303 VinylSim, 404 VinylSim, Cassette Sim, Lo-fi, Equalizer, Compressor
Effects marked with an (*) are for INPUT FX only.
You can set the bus to which the playback audio signals coming into the INPUT jack are sent (meaning which
effects are used).
DRY
Input Bus
BUS1, BUS2
This sets the routing for audio sent to the DRY bus.
112
Value
Value
Value
Explanation
Selects the effects
assigned to BUS 3 or
BUS 4.
For details on the
parameters of each
effect, refer to "MFX
List(P.114)".
Explanation
You can assign the
effects you like to the
effect buttons on the
top panel.
For details on the
parameters of each
effect, refer to "MFX
List(P.114)".
Explanation
Both BUS 1 and BUS 2 are
muted.
Only the bus selected with the
[BUS FX] button is muted.
You can apply effects to the
audio that's inputted to this unit.
For details on the parameters of
each effect, refer to "MFX
List(P.114)".
The signal is not sent to BUS 1,
BUS 2 (the BUS 1 and BUS 2
effects are not used).
The signal is sent to BUS 1 or
BUS 2. The effects set for BUS 1
and BUS 2 are used.