Roland SP-404MK2 Reference Manual page 109

Parameter Value
This selects the point (time) at which reverse playback begins when you press the [REVERSE] button during
sample playback.
Reverse Type 404
303
This selects where the audio signal input from the USB port is sent.
LINE IN
USB IN
MIX OUT
CLICK
Parameter Value
OFF, ON
Output Assign
Click Level 1–5
Metronome:REC OFF, ON
Metronome:PTN OFF, ON
This selects how sampling or resampling starts.
OFF
1 MEAS, 2
Count-In:REC
MEAS
WAIT
This selects how pattern recording begins.
OFF
1 MEAS, 2
Count-In:PTN
MEAS
WAIT
MIDI
Parameter Value
Specifies the tempo source.
Auto
MIDI Sync
Internal
MIDI
USB
MIDI Sync OFF,
Out ON
SEQ Note OFF,
Out ON
Soft OFF,
Through ON
OFF,
USB-MIDI
ON
Thru
Starts reverse playback at the sample's end point. This works the same as the SP-
404SX.
Starts reverse playback immediately from the playback position of the current
sample. This works the same as the SP-303
Mixes the USB audio signal with the audio signal from the LINE IN jacks.
Mixes the USB audio signal with the MIXER output, without going through the INPUT
FX or BUS FX.
When this is set to ON, the metronome sound is output from the LINE OUT jacks and from
the USB port.
Sets the volume of the metronome.
When this is ON, the metronome sound is output while you are sampling or resampling.
When this is ON, the metronome sound is output when a pattern is being recorded.
Sampling or resampling starts at the same time that you press the [REC] button.
When you press the [REC] button, a count-in begins one or two measures before where
sampling or resampling begins.
Sampling or resampling starts when you press a pad to play back a sample, or when
audio is detected from an external device.
Pattern recording starts at the same time that you press the [REC] button.
When you press the [REC] button, a count-in of one or two measures begins before
pattern recording starts.
Pattern recording starts when you press a pad to play back a sample, or when audio is
detected from an external device.
The tempo automatically synchronizes to the MIDI clocks if MIDI clocks are input via the MIDI IN
connector or the USB port.
The tempo specified on this unit is used.
The tempo synchronizes to the MIDI clocks received via the MIDI IN connector.
The tempo synchronizes to the MIDI clocks received via the USB port.
When this is ON, clocks, start and stop are transmitted to the device connected to this unit's MIDI
OUT connector.
When this is set to "ON", the note number corresponding to the pattern (pad) is output via the
MIDI OUT connector when the pattern plays back.
If this is ON, MIDI messages that are inputted to the MIDI IN connector are re-transmitted without
change from the MIDI OUT connector.
When this is ON, MIDI signals that are inputted via the USB port are outputted to the MIDI OUT
connector. MIDI signals that are inputted via the MIDI IN connector are also outputted to the USB
port.
Explanation
Explanation
Explanation
Appendix
109