Installing The Stand - HP t5145 Hardware Reference Manual

3. Align the feet with their holes and press them in securely.
Figure 1-5

Installing the Stand

If your unit does not have VESA mounting holes, you will need to use the thin client in a vertical
orientation and install the stand for stability.
To install the stand:
1. Turn unit upside down.
2. Locate the slots on the bottom of the unit into which the tabs on the stand fit. Position the stand
with the wide part toward the front of the unit. Align the tabs on the widest part of the stand with
the slots approximately 7.6 cm (3 inches) from the front of the unit and the tabs on the narrower
part with the slots approximately 3.8 cm (1.5 inches) from the rear of the unit.
3. Insert the tabs into the slots, then press the stand down and slide it toward the rear of the thin client
until it locks into place.
Figure 1-6
6 Chapter 1 Product Features
Installing the rubber feet
Installing the stand