Removing And Replacing The Battery - HP t5145 Hardware Reference Manual

Removing and Replacing the Battery

Before beginning the replacement process, review
on page 11
WARNING!
power cord is disconnected from the electrical outlet.
To remove and replace the battery:
1. Locate the battery on the system board.
2. To release the battery from its holder, gently push the metal guard (1) that extends above one edge
of the battery very slightly toward the rear of the unit, then lift the battery out (2).
NOTE:
Figure 2-8
3. Slide one edge of the battery into the slot and push down until the guard snaps over the edge of
the battery .
HP encourages customers to recycle used electronic hardware, HP original print cartridges, and
rechargeable batteries. For more information about recycling programs, go to
search for "recycle".
for procedures you should follow before and after installing or replacing hardware.
Before removing the side access panel, ensure that the thin client is turned off and the
Be careful not to bend the metal guard.
Removing and replacing the internal battery
Batteries, battery packs, and accumulators should not be disposed of together with the general household
waste. In order to forward them to recycling or proper disposal, please use the public collection system
or return them to HP, an authorized HP partner, or their agents.
The Taiwan EPA requires dry battery manufacturing or importing firms, in accordance with Article 15 or
the Waste Disposal Act, to indicate the recovery marks on the batteries used in sales, giveaways, or
promotions. Contact a qualified Taiwanese recycler for proper battery disposal.
General Hardware Installation Sequence
Installing Thin Client Options
http://www.hp.com and
17