Installing The Stand; Removing The Stand - HP Compaq GT7720 Hardware Reference Manual

3. Align the feet with their holes and press them in securely.
Figure 1-6

Installing the Stand

To install the stand:
1. Turn unit upside down.
2. Locate the slots on the bottom of the unit into which the tabs on the stand fit.
3. Insert the tabs into the slots (1), and then slide the stand about 1.26 cm (1/2 inch) toward the back
of the unit until it locks into place (2).
Figure 1-7

Removing the Stand

To remove the stand:
1. Turn unit upside down.
6 Chapter 1 Product Features
Installing the rubber feet
Installing the stand
ENWW