Installing The Rubber Feet; Installing The Stand; Removing The Stand - HP T5730 - Compaq Thin Client Troubleshooting Manual

Installing the Rubber Feet

To install the rubber feet:
1. Locate the holes in the corners of the left side of the thin client.
2. Remove the feet from their backing.
3. Align the feet with their holes and press them in securely.

Installing the Stand

To install the stand:
1. Turn unit upside down.
2. Locate the slots on the bottom of the unit into which the tabs on the stand fit.
3. Insert the tabs into the slots (1), and then slide the stand about 1.26 cm (1/2 inch) toward the back
of the unit until it locks into place (2).

Removing the Stand

To remove the stand:
Product features 5