Guide Rails - Delta ShopMaster TS300 Instruction Manual

GUIDE RAILS

1. Align the three slotted holes in the front right guide
rail (A) Fig. 14, with two holes (B) in saw table and
slotted hole (C) in extension wing. Insert a M6x1x20mm
carriage head screw (D) Fig. 14, through the three holes
in the front right guide rail, and the saw table. Place a
M6.4 flat washer (E), and a 6.1 lockwasher (F) onto the
carriage head screw (D). Thread a M6x1 hex nut (G) onto
the carriage head screw (D) and hand tighten only.
NOTE: TIGHTEN HARDWARE JUST ENOUGH TO
HOLD RAIL IN PLACE AT THIS TIME.
2. Insert longer end of front guide rail extension
connector (H) Fig. 15, into end of guide rail (A).
3. Assemble front left guide rail (J) Fig. 16, onto
extension connector (H). Align the two slotted holes in
guide rail extension (J) Fig. 16 with hole (K) in table and
extension wing (L). Insert a M6x1x20mm carriage head
screw (D) Fig. 16, through the two holes in the front left
guide rail, and the saw table. Place a M6.4 flat washer
(E), and a 6.1 lockwasher (F) onto the carriage head
screw (D). Thread a M6x1 hex nut (G) onto the carriage
head screw (D) and hand tighten only. NOTE: TIGHTEN
HARDWARE JUST ENOUGH TO HOLD RAIL IN
PLACE AT THIS TIME.
4. Fig. 17 illustrates the front guide rail loosely
assembled to the table saw.
H
F D
E
G
12
G
F
E
D
Fig. 14
A
Fig. 15
K
L
Fig. 16
Fig. 17
C
A
B
H
J