Table of Contents
Advertisement
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
STAND
Assemble stand as shown in Figs. 4 and 5 using parts
shown in Fig. 3. The braces, legs and feet are labeled
the same in all three illustrations. Insert the
M8x1.25x16mm carriage head screws through legs and
braces then place the 3/8" flat washers on the screws
and secure with the M8x1.25 hex nuts. Only tighten nuts
finger-tight at this time. NOTE: The top lips of the two
top side braces (9) Fig. 4, must fit on top of the top lips
of the front and rear braces (1). The side braces (9) have
holes on top for mounting the saw to the stand.
SAW TO STAND
1. Turn saw table face down on a piece of cardboard
to protect the table surface. Align the four holes in the
saw cabinet with the four holes in the stand.
2. Place a 3/8" flat washer onto a M8x1.25x16mm hex
head screw. Insert the screw through the hole in the
stand and the hole in the saw. Place a 3/8" flat washer
onto the screw and thread a M8x1.25 hex nut onto the
screw and tighten securely. Repeat this process for the
three remaining holes.
3. Turn saw table face up, as shown in Fig. 6.
4. Push down on top of saw so the legs of the stand
adjust to the surface of the floor and tighten all stand
hardware.
ASSEMBLY
9
9
1
8
2
2
Fig. 4
4
Fig. 5
Fig. 6
9
8
3
4
Advertisement
Table of Contents
