Table of Contents
Advertisement
BLADE GUARD AND
SPLITTER ASSEMBLY
DISCONNECT MACHINE FROM POWER
SOURCE.
1. Thread a M12x1.75 hex nut (A) onto the splitter
support rod (R) Fig. 26, as far as it will go.
2. Place a 5/8" flat washer (B) Fig. 26, onto the splitter
support rod (R).
3. Place the splitter bracket (C) Fig. 26, onto the splitter
support rod (R).
4. Place a 5/8" flat washer (B) Fig. 26, onto the splitter
support rod (R).
5. Thread a M12x1.75 hex nut (D) onto the splitter
support rod (R) Fig. 26 and tighten the nut to hold the
splitter bracket (C) in place.
6. Align the hole in the blade guard and splitter
assembly (E) Fig. 27, with the hole in the splitter bracket
(C). NOTE: Make certain the two protrusions, "pins" (G)
Fig. 28, are engaged with the channel of the splitter
assembly.
7. Place a 1/4" external tooth lockwasher and a 5/16"
lockwasher onto a M6x1x20mm hex head screw. Insert
the hex head screw (D) Fig. 27, through the hole in the
support bracket, and through the slot in the blade
guard/splitter assembly.
8. Place a 1/4" external tooth lockwasher and a 5/16"
lockwasher onto a M6x1x20mm hex head screw (D) Fig.
27. Thread a M6x1 wing nut (F) Fig. 28, onto the end of
the hex head screw.
9.
NOTE: Before tightening wing nut (F) Fig. 28, make
certain there is at least a 1/8" gap between the bottom
edge of splitter (N) and top surface of table (P).
10. Using a straight edge, check to see if the splitter (E)
Fig. 29, is aligned with the saw blade (R). If an
adjustment is necessary, the splitter (E) can be moved
left or right and rotated by loosening nut (A) Fig. 29, and
adjust accordingly.
N
G
F
R
15
C
A
R
D
B
Fig. 26
E
C
D
Fig. 27
P
Fig. 28
A
Fig. 29
E
Advertisement
Table of Contents
