Front And Rear Rails - Delta 36-5100 T2 Instruction Manual

FRONT AND REAR RAILS

Hardware Bag "C, D"
1.
Using the supplied 3/16 inch T-Handle Allen Wrench, attach
the Front Rail [1] to the table front with two 5/16-18 x
PC18
1 1/8 inch Flat Countersunk Hex Screw
18 Hex Flange Nuts
2.
Using the supplied 3/16 inch T-Handle Allen Wrench, attach
the Rear Rail [2] to the table back using two 5/16-18 x
PC17
7/8 inch Hex Screw with Split Lock Washer
7.
NOTE: Use the two aligning holes which are spaced 16 inch apart
to align the front and rear rails to the table aligning holes which
are also spaced 16 inch apart.
3.
Use supplied Rail Alignment Gauge
the proper distance from the top of the table at each side
of the cast iron table. See Figure 6.
and two 5/16-
HP15
. See Figure 5.
HP14
. See Figure
HP7
to ensure the rail is
HP20
ASSEMBLY
PC20
Rear Rail
18
Front Rail Front Rail
1
Figure 5
Figure 6
2
Figure 7
HP14
HP15
FRONT
BACK
HP14
HP7