Updating The Device Certificate - Canon Scan Kiosk II Setup And Administration Manual

2.4

Updating the Device Certificate

This section describes how update the device certificate.
The Scan Kiosk II initial setup automatically generates a self-signed device certificate,
which is based on the given device name during the setup. It is highly recommended
that the Administrator create a device certificate that is signed by a certificate authority,
and which is recognized by the enterprise.
If the device name was changed after the initial setup and the device certificate was not
updated, browsers will have security issues connecting to the Scan Kiosk II device. To
avoid this, the device certificate must be updated. If the Administrator prefers to use the
self-signed certificate, use the procedure below to update that certificate.
IMPORTANT
Be careful when you perform operations in the Windows Admin Mode. Any
procedures that are not mentioned in this guide, may disable the Scan Kiosk II device.
1. Log on to the Windows Admin Mode.
For instructions, see
2. From the Desktop, open the [Device Certificate Install] folder.
32
"Logging On to the Windows Admin Mode,"
Scan Kiosk II V2.0 Setup and Administrator's Guide
on p. 27.