Compaq Deskpro AP400 Reference Manual page 50

3-14 Security Features
4. On SW1, move switch 1 to the ON position, as shown in Figure 3-2.
IMPORTANT: Switch 1 has a default setting of OFF. When the switch is
OFF, your system is password-protected. To re-enable password protection,
you MUST return the switch to its default position later in this procedure.
5. Reinstall the expansion board bracket. Reconnect the power cord to the
grounded AC outlet and to the power connector on the rear of the
workstation.
IMPORTANT: You must reinstall the expansion board bracket before you
restart your workstation. if the bracket is not properly seated, the workstation
will not start.
6. Restart the workstation to erase the password from system memory.
NOTE: Clearing the Setup Password will also clear the Power-on Password.
Be sure to reestablish your Power-on Password after clearing the Setup
Password.
7. Turn off the workstation once more. Disconnect the power cord from
the grounded AC outlet and from the power connector on the rear of the
workstation.
8. Remove the expansion board bracket to access SW1.
9. On SW1, return switch 1 to its original default (OFF) position.
10. Reassemble the workstation.
11. Establish a new Setup Password and Power-on Password, if desired.
Writer: John Turner Project: Compaq Professional Workstation AP400 Reference Guide Comments: 317787-003
File Name: D-CH03.DOC Last Saved On: 12/17/98 1:36 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED