Compaq Deskpro AP400 Reference Manual page 49

Clearing a Setup Password
If you forget your Setup Password, you cannot use the Computer Setup utility
to change the configuration settings. You may view the current settings, but
you may not change them unless you know the Setup Password.
To clear the Setup Password:
1. Turn off the workstation. Disconnect the power cord from the grounded
AC outlet and from the power connector on the rear of the workstation.
2. Remove the following components:
workstation cover
expansion board bracket
3. Locate the SW1 switch on the system board.
SW1
Figure 3-2. Locating the SW1 switch
NOTE: White indicates the switch position
Writer: John Turner Project: Compaq Professional Workstation AP400 Reference Guide Comments: 317787-003
File Name: D-CH03.DOC Last Saved On: 12/17/98 1:36 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
C C C C C C C C C S  S  C S  C S  C C C S  C C C S  C C C S  C C C S  C C C S  C C C S  C C C S  C C C S  S  C S  S  S  C S  S  S  C S  S  S  C S  S  S  C S  S  S  C S  S  S  C S  S  S  C S  S  S  C S  S  S  C S  S  S  C S  S  S  R  R B B R  R  R  R  R  B R  B R  R  B  R  B B R  B B B B B R  R  R  R  R  R  R  R  B R  B B R  B R  R  R  B R  R  R  B R  R  R  B R  R  R  B R  R  R  B R  R  R  B R  R  R  B R  R  R  B R  B R  R  R  B R  R  R  B R  R  B B B R  B B B R  B B B R  B B B R  B B B R  B B B R  B B B R  B B B R  B B B R  B B B R  B B B R  B B B R  B B B R  B B B R 
on
1 2 3 4 5 6
Compaq Professional Workstation AP400 Reference Guide
3-13