Converting A Minitower To A Desktop Configuration; Figure 3-35. Removing The Battery - Compaq Deskpro Workstation AP250 Maintenance And Service Manual

4. Lift the battery out of the holder.

Figure 3-35. Removing the battery

To replace the battery, slide the replacement battery into position with the
positive side up. The battery holder automatically secures the battery in the
proper position.
IMPORTANT: Positive polarity should be positioned up.
Converting a Minitower to a Desktop
Configuration
To convert a minitower to a desktop configuration:
1. Perform the steps in the "Service Preparations" section.
2. Remove the side access panel.
3. Remove the front bezel.
Compaq Confidential – Need to Know Required
Writer: Bruce Sullivan Project: Compaq Deskpro Workstation AP250 Maintenance and Service Guide Comments:
Part Number: 118133-001 File Name: d-ch3 Removal and Replacement Procedures.doc Last Saved On: 10/26/99 3:02 PM
CAUTION: Before removing the side access panel, ensure that the workstation
is turned off, all cables are disconnected from the back of the workstation, and
the power cord is disconnected from the grounded AC outlet.
Removal and Replacement Procedures 3-41