Removing The Speaker; Figure 3-28. Removing The Processor Guide Rails From The System Board - Compaq Deskpro Workstation AP250 Maintenance And Service Manual

4. Using a Torx T-15 screwdriver, loosen the four claynuts 1 that attach
the processor guide rails to the system board, then remove the rails 2.

Figure 3-28. Removing the processor guide rails from the system board

To replace the processor guide rails, seat the guide rails flush with the system
board, then tighten the four claynuts.

Removing the Speaker

To remove the speaker:
1. Perform the steps in the "Service Preparations" section.
2. Remove the side access panel.
3. Disconnect the speaker cable from the system speaker connector on the
system board.
Compaq Confidential – Need to Know Required
Writer: Bruce Sullivan Project: Compaq Deskpro Workstation AP250 Maintenance and Service Guide Comments:
Part Number: 118133-001 File Name: d-ch3 Removal and Replacement Procedures.doc Last Saved On: 10/26/99 3:02 PM
1
CAUTION: Before removing the side access panel, ensure that the workstation
is turned off, all cables are disconnected from the back of the workstation, and
the power cord is disconnected from the grounded AC outlet.
Removal and Replacement Procedures 3-33
2