3-18 Compaq Deskpro Workstation AP250 Maintenance and Service Guide
Writer: Bruce Sullivan Project: Compaq Deskpro Workstation AP250 Maintenance and Service Guide Comments:
Part Number: 118133-001 File Name: d-ch3 Removal and Replacement Procedures.doc Last Saved On: 10/26/99 3:02 PM
6. While holding the drive casing, pull the drives out of the drive bay 1.
7. Remove the four guide screws 2.
Figure 3-16. Removing a CD-ROM drive from a 5.25-inch drive bay
To replace the CD-ROM drive:
1. Install two M3 guide screws on each side of the replacement 5.25-inch
drive (in the bottom holes), making sure the guide screws line up with
the guide slots.
2. Slide the drive into the drive bay until it locks into place.
Compaq Confidential – Need to Know Required
2
2
1