Removing An Expansion Slot Cover - Compaq Deskpro Workstation AP240 Reference Manual

Removing an Expansion Slot Cover

1. If you have locked the Smart Cover Lock, use Computer
2. Shut down the operating system properly, turn off the
3. Remove the workstation cover.
4. Raise the expansion card cage by lifting and locking the
5. Locate the correct vacant slot in the expansion card cage.
6. Remove the screw at the side of the expansion slot, then
Removing a Screw and Expansion Slot Cover
Setup to unlock the lock and disable the Smart Cover
Sensor.
workstation and any external devices, then disconnect the
power cord from the power outlet.
two green levers. You do not need to remove the cage from
the chassis.
remove the expansion slot cover from the slot as
illustrated.
You will need to slide the system board tray backward a
short distance to access the screws for the first and
second slots.
Reference Guide 5-13