Canon imagePROGRAF iPF8300 Basic Guide No.2 Basic Manual page 36

Error Messages
Error Message
Regular printing is selected, but
a roll is loaded.
No sheets.
Cannot adjust paper feed.
End of paper feed.
Calibration There is a problem
with the multi-sensor.
Cause
A print job for printing on sheets
was sent when a roll is loaded.
You are using a roll with the Media
Take-up Unit , but a print job
requiring sheets was sent.
A sheet has come out of the printer
during printing.
The Printhead nozzles are
clogged.
Highly transparent film is loaded
that cannot be used for automatic
feed amount adjustment.
You are pressing the ▲ button on
the Control Panel and trying to
rewind the roll to the edge.
Paper can be retracted only up
to 17 mm (0.7 in) when using the
Media Take-up Unit .
The performance of a sensor
inside the printer may be impaired.
36
Corrective Action
1. Press ▲ or ▼ to select Remove Roll Paper , and
then press the OK button to stop printing.
2. After removing the roll, load and print on a sheet of
the type and size of paper you have specified in the
printer driver.
(→ , Removing the Roll from the Printer)
(→"Loading and Printing on Sheets," User Manual)
Press ▲ or ▼ to select Stop Printing , and then press
the OK button to stop printing.
1. Press the OK button to stop printing.
2. After removing the roll, load and print on a sheet of
the type and size of paper you have specified in the
printer driver.
(→ , Removing the Roll from the Printer)
(→"Loading and Printing on Sheets," User Manual)
1. Lift the Release Lever and remove the paper.
2. If Not finished printing. Finish printing
remaining jobs? is shown on the Display Screen ,
press the OK button.
Printing will resume, starting from the page on
which the error occurred.
Execute Adj. Quality again, as follows.
1. Press the OK button to clear the error.
2. Print a test pattern to check the nozzles.
(→"Checking for Nozzle Clogging," User Manual)
3. Clean the Printhead if the nozzles are clogged.
(→ , If Printing is Faint)
4. Execute Adj. Quality again.
(→ , If Banding Occurs)
Press the OK button to clear the error, and then adjust
the feed amount manually.
(→"Manual Banding Adjustment (Adj. Quality)," User
Manual)
Release the ▲ button.
Release the ▲ button.
Press the OK button and cancel calibration. Contact
your Canon dealer for assistance.