Canon imagePROGRAF iPF8300 Basic Guide No.2 Basic Manual page 9

Large format printer
Hide thumbs Also See for imagePROGRAF iPF8300 Basic Guide No.2:
Table of Contents

Advertisement

Phenomenon
The surface of the paper is dirty
The back side of the paper is dirty
Cause
The Paper Retainer is soiled.
You are using a paper that does
not dry easily.
The Platen has become dirty after
borderless printing or printing on
small paper.
The Platen has become soiled
because you have set Width
Detection to Off in the Control
Panel menu.
The Paper Retainer is soiled.
Corrective Action
Clean the Paper Retainer .
(→
, If Paper is Soiled)
In the Control Panel menu, set Roll DryingTime to
at least 1 min.
(→
, Menu Map)
When paper that does not dry easily is used for
printing, it may curl during printing and touch the
output tray.
In this case, in the Control Panel menu, set Scan
Wait Time to an option other than Off .
However, note that printing will now take longer.
(→
, Menu Map)
Open the Top Cover and clean the Platen .
(→
, If Paper is Soiled)
In the Control Panel menu, set CarriageScanWdth
to Fixed .
(→
, Menu Map)
Set Width Detection to On in the Control Panel
menu, and then open the Top Cover and clean the
Platen .
(→
, If Paper is Soiled)
Open the Top Cover and clean the Platen . After this,
manually advance the roll onto the Platen before
printing.
(→
, If Paper is Soiled)
(→"Feeding Roll Paper Manually," User Manual)
Clean the Paper Retainer .
(→
, If Paper is Soiled)
9
Troubleshooting

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents