Canon imagePROGRAF iPF8300 Basic Guide No.2 Basic Manual page 43

Error Message
Maint. cart. The level is low
Maintenance cartridge problem.
Maintenance cartridge full.
No maintenance cartridge.
Wrong maintenance cartridge.
No Maintenance Cartridge
capacity.
The paper is too small.
Cause
The Maintenance Cartridge is
almost full.
An incompatible or used
Maintenance Cartridge has been
installed.
The Maintenance Cartridge is full.
The Maintenance Cartridge is not
installed.
A Maintenance Cartridge for
a different model of printer is
installed.
The Maintenance Cartridge cannot
absorb enough ink for Printhead
cleaning or other operation.
When Detect Mismatch in the
Control Panel menu is set to
Pause , paper smaller than the size
specified in the printer driver is
loaded.
When Detect Mismatch in the
Control Panel menu is set to
Warning , paper smaller than the
size specified in the printer driver
is loaded.
43
Corrective Action
You can continue to print, but prepare a new
Maintenance Cartridge to use when the message for
replacement is displayed.
Install an unused Maintenance Cartridge specified for
use with the printer.
(→ , Replacing the Maintenance Cartridge)
After confirming that the printer has stopped
operating, replace the Maintenance Cartridge .
(→ , Replacing the Maintenance Cartridge)
Install the Maintenance Cartridge .
(→ , Replacing the Maintenance Cartridge)
Replace it with the Maintenance Cartridge for your
particular model.
After confirming that the printer has stopped
operating, replace the Maintenance Cartridge .
(→ , Replacing the Maintenance Cartridge)
Press ▲ or ▼ to select Print , and then press the OK
button to resume printing.
However, note that this error may cause paper jams
and affect the printing quality.
Adjust the paper size setting in the printer driver to
match the size loaded in the printer as follows.
1. Press ▲ or ▼ to select Stop Printing , and then
press the OK button to stop printing.
2. Change the paper size setting in the printer driver to
the size loaded in the printer and try printing again.
Replace the loaded paper with paper of a size that
matches the size setting in the printer driver as
follows.
1. Press ▲ or ▼ to select Change Paper , and then
press the OK button to stop printing.
2. Replace the loaded paper to match the paper width
setting in the printer driver and try printing again.
You can continue to print, but note that this error may
cause problems in the printing results.
Error Messages