Canon imagePROGRAF iPF8300 Basic Guide No.2 Basic Manual page 32

If Line Length Does Not Match
3
Press the OK button.
The Set./Adj. Menu is displayed.
4
Press ▲ or ▼ to select Adjust Printer , and then press
the OK button.
5
Press ▲ or ▼ to select Feed Priority , and then press the
OK button.
6
Press ▲ or ▼ to select Adjust Length , and then press
the OK button.
7
Press ▲ or ▼ to select AdjustmentPrint or Change
Settings , and then press the OK button.
When you select AdjustmentPrint , a test pattern is
printed for you to measure the scale and calculate the
discrepancy. The scale bar shows " Millimeter " in 50 mm
increments and " Inch " in 1-inch increments.
• A test pattern is printed in black when you choose A:High or in magenta if you choose B:Standard/
Draft .
• To cancel printing the test pattern for adjustment, hold down the Stop button. When Stop printing? is
displayed, press ▲ or ▼ to select Yes , and then press the OK button.
8
Press ▲ or ▼ to enter the amount of discrepancy, and
then press the OK button.
If the scale is shorter than the actual size, use a positive
setting value. If it is longer, use a negative value.
The feed amount can be adjusted in 0.02% increments.
32
Millimeter Inch