Operating The Trimmer; After Finishing Work; Transporting - Stihl FSA 60 R Instruction Manual

English
► If the LEDs do not glow or flash: Do not use
the battery and contact your STIHL servicing
dealer.
There is a malfunction in the battery.

12 Operating the Trimmer

12.1 Holding and Controlling the
Brushcutter
► Hold the brushcutter firmly with one hand on
the control handle – wrap your thumb around
the handle.
► Hold the brushcutter with the other hand on
the loop handle such that your thumb holds
the loop handle.
12.2 Mowing
The cutting height is determined by the distance
of the cutting attachment from the ground.
► Swing the brushcutter steadily back and forth
in an arc.
► Move forward slowly in a controlled manner.
► If you work with a bump guard (1): Extend the
bump guard (1) fully.
12.3 Line Feed on AutoCut Mowing
Heads
► Briefly tap the rotating mowing head on the
ground.
About 30 mm of fresh nylon line is advanced.
The line limiting blade in the deflector auto‐
matically cuts the mowing lines to the correct
length.
36
Automatic feed will not take place if the mowing
lines are shorter than 25 mm.
► Switch off the brushcutter and remove the bat‐
tery.
► Depress the spool (1) on the mowing head
and hold it depressed.
► Pull out the mowing lines (2) by hand.
► If the mowing lines (2) cannot be pulled out to
the required length: Replace the spool (1) or
the mowing lines (2).
The spool is empty.

13 After Finishing Work

13.1
► Switch off the trimmer and remove the battery.
► If the trimmer is wet: Allow the trimmer to dry.
► If the battery is wet: Allow the battery to dry.
► Clean the trimmer.
► Clean the deflector.
► Clean the cutting attachment.
► Clean the battery.

14 Transporting

1
14.1
► Switch off the brushcutter and remove the bat‐
tery.
Carrying the Brushcutter
► Carry the brushcutter in one hand properly
balanced by the shaft, with the cutting attach‐
ment behind you.
Transporting the brushcutter in the car
► Secure the brushcutter to prevent turnover
and movement.
14.2
► Switch off the brushcutter and remove the bat‐
tery.
► Check that the battery is in a safe condition.
► Pack the battery in packaging in such a way
that it cannot move inside the packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the Carriage of Danger‐
ous Goods regulations. The battery is classified
12 Operating the Trimmer
2 1
After Finishing Work
Transporting the brushcutter
Transporting the Battery
0458-832-9821-C