Download Print this page

Assembling The Trimmer - Stihl FSA 60 R Instruction Manual

Hide thumbs Also See for FSA 60 R:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 22

7 Assembling the Trimmer

The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
19.
Malfunction in trimmer or battery.
6.5
LED on Charger
The LED indicates the operating status of the
charger.
If the LED glows green, the battery is being
charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.
7
Assembling the Trimmer
7.1
Mounting the bump guard
► Switch off the brushcutter and remove the bat‐
tery.
► Insert the ends of the bump guard (1) into the
holes (2) in the housing.
The bump guard (1) need not be removed.
7.2
Mounting the guard
► Switch off the brushcutter and remove the bat‐
tery.
1
2
The line limiting blade (1) has already been
installed in the guard (2) and must not be
removed.
► Push the guard (2) into the guides on the
housing until it hits the limit stop.
The guard (2) is flush with the housing.
► Insert and tighten down the screws (3).
The guard (2) must not be removed.
0458-832-9821-C
2
2
1
2
7.3
Mounting the Loop Handle
► Switch off the brushcutter and remove the bat‐
tery.
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the
shaft (5).
► Fit the washers (2) on the screws (1).
► Press the clamp (6) against the shaft (5).
► Insert the screws (1) through holes in the loop
handle (3) and clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
7.4
Mounting and Removing the
Mowing Head
7.4.1
AutoCut C 6-2 mowing head
Mounting the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
1
3
► Position the mowing head (1) on the shaft (2).
► Hold the mowing head (1) with your hand.
► Manually rotate the cap (3) clockwise and
tighten it.
Removing the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
► Hold the mowing head with your hand.
► Manually rotate the cap counterclockwise until
the mowing head can be removed.
7.4.2
PolyCut 6-2 mowing head
Mounting the Mowing Head
► Switch off the brushcutter and remove the bat‐
tery.
1
2
3
4
5
6
7
3
2
English
1
33

Advertisement

loading