Table of Contents
Advertisement
Accessory List
Main unit ................................................................................................. 1
Quick Reference Guide ................................................................. 1set
<Cables>
Power cable ............................................................................................ 1
USB extension cable ............................................................................ 1
PRE OUT cable ....................................................................................... 1
Microphone ............................................................................................ 1
CAN Interface Connector .................................................................. 1
<Main unit mounting parts>
Screw (M5×8) ......................................................................................... 4
Installation
Caution
• Do not block the unit's fan, thus preventing air
circulation. If blocked, heat will accumulate inside the
unit and may cause a fire.
Heat sink
Rear of the Unit
Caution concerning the installation
location
Angle of installation
Install at an angle between horizontal and 30°. Note that
installing at an angle outside of this range will result in a
loss of performance and possibly damage.
Mounting the Microphone
For safe use, make sure of the following:
• Location is stable and firm.
• Does not interfere with safety equipment.
• Driver's view and operations are not obstructed.
• Microphone is located where the driver's voice can be
easily picked up (for example, on the sun visor).
60
-EN
When you speak into the microphone, you should not have
to change your driving posture. This may cause a
distraction, taking your attention away from safely driving
your vehicle. Carefully consider direction and distance while
mounting the microphone. Confirm that the driver's voice
can be easily picked up at the selected location.
Cable clamp
(sold separately)
Installation example using the
Original Mounting Bracket
1
Original Mounting Bracket
Ground Lead*
2
3
0 - 30°
* To securely connect the ground lead, use an already
• Fix the cables carefully. Do not damage them by
4
Microphone
Mount the original mounting bracket to the
unit using the supplied screws.
Chassis
Connect all other leads of the unit according
to details described in the "Connections"
(page 61).
Mount the unit in a car.
installed screw on a metal part of the vehicle (marked
( )) or a clean, bare metal spot on the vehicle's
chassis.
mounting them into movable parts, such as the seat
rail, or by locating them against sharp or pointed
edges.
Reattach the removed vehicle parts (panels,
etc.) or other aftermarket dash kit back onto
the vehicle.
Screws (M5×8)
(included)
Advertisement
Table of Contents
