Bootable Devices in Computer Setup
The notebook can start up from a USB device or the NIC only if
that device has been enabled for inclusion in MultiBoot.
To enable a device or location for inclusion in MultiBoot:
1. Open Computer Setup by turning on or restarting the
notebook. Press
message is displayed in the lower-left corner of the screen.
❏
❏
2. To enable bootable media in USB drives or in drives inserted
into an optional docking device, use the arrow keys to select
the Advanced menu > Device Options. Then select Enable
USB legacy support.
– or –
To enable a NIC, select Security menu > Device security,
and then select Internal network adapter boot.
3. Save your preferences and exit Computer Setup by using the
arrow keys to select File > Save Changes and Exit. Then
follow the instructions on the screen.
Your preferences are set when you exit Computer Setup and take
effect when the notebook restarts.
✎
To connect a NIC to a Preboot eXecution Environment (PXE) or
Remote Program Load (RPL) server during startup without using
MultiBoot, quickly press
message is displayed in the lower-left corner of the screen.
Hardware and Software Guide
f10
To change the language, press
For navigation instructions, press
while the F10 = ROM Based Setup
f2.
when the Network Service Boot
f12
f1.
MultiBoot
B–4