Omron NX-PA Series User Manual page 52

1 Introduction to NX-series Controllers
 Network Configurations
• Host computers, HMIs, and other NJ/NX-series Controllers are connected to the built-in Ether-
Net/IP port.
• A DeviceNet network is connected to a CJ-series DeviceNet Unit. A serial communications net-
work is connected to a CJ-series Serial Communications Unit.
FA Communications
Information
Level
EtherNet/IP
Built-in EtherNet/IP port
NJ-series
CPU Unit
CompoNet Master Unit
DeviceNet Unit
Field Level
CompoNet
MS NS WORD NODE ADR 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 MS NS WORD NODE ADR 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
OUT OUT
CRT1 CRT1-OD16 OD16 CRT1-OD16 CRT1 OD16
REMOTE TERMINAL REMOTE TERMINAL
CompoNet slaves
DeviceNet slaves
Refer to the NJ/NX-series CPU Unit Software User's Manual (Cat. No. W501) for details on the net-
work configuration.
1 - 6
Sysmac
Software Studio
Built-in EtherNet/IP port
NX-series
CPU Unit
Serial
Communications
Unit
RS-232C,
RS-422A/485
Serial communications devices
MS NS WORD NODE ADR 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
OUT
CRT1 CRT1-OD16 OD16
REMOTE TERMINAL
General-purpose components or OMRON components
DeviceNet
FA Wireless
LAN Unit
Programmable
Terminal
Built-in EtherCAT port
EtherCAT
General-purpose
slaves
EtherCAT
Servo Drives
Slave Terminal
EtherNet/IP
RFID Systems
NX-series CPU Unit Hardware User's Manual (W535)
NJ/NX-series
CPU Unit
Vision
Systems
Robots