Serial Connector And Cable - HP Compaq 6730b Maintenance And Service Manual

3. Release the RJ-11 connector (4) from the clip built into the base enclosure.
4. Remove the modem module cable.
Reverse this procedure to install the modem module cable.

Serial connector and cable

NOTE: The serial connector and cable is included in the Cable Kit, spare part number 487138-001.
Before removing the serial connector and cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. Remove the following:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Switch cover (see
e. Display assembly (see
f. Top cover (see
g. Rear cover (see
Battery on page 46).
Hard drive on page 52)
Optical drive on page
Keyboard on page 60)
Switch cover on page
Display assembly on page
Top cover on page 80)
Rear cover on page 91)
55)
65)
74)
Component replacement procedures 95