Sim Connector Board - HP Compaq 6730b Maintenance And Service Manual

SIM connector board

NOTE: This section applies only to computer models equipped with a WWAN module.
Description
SIM connector board
Before removing the SIM connector board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. Remove the following:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Switch cover (see
e. Display assembly (see
f. Top cover (see
g. Rear cover (see
Remove the SIM connector board:
1. Remove the two Phillips PM2.5×5.0 screws (1) that secure the SIM connector board to the base
enclosure.
2. Lift the left side of the SIM connector board (2) to disconnect it from the system board.
Battery on page 46).
Hard drive on page 52)
Optical drive on page
Keyboard on page 60)
Switch cover on page
Display assembly on page
Top cover on page 80)
Rear cover on page 91)
55)
65)
74)
Component replacement procedures
Spare part number
486252-001
93