Optical Drive Connector Board - HP Compaq 6730b Maintenance And Service Manual

Optical drive connector board

Description
Optical drive connector board
Before removing the optical drive connector board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. Remove the following:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Switch cover (see
e. Fan (see
f. Heat sink (see
g. Display assembly (see
h. Top cover (see
i. ExpressCard board (see
j. Audio board (see
k. Speaker (see
l. Rear cover (see
m. SIM connector board (see
n. System board (see
Remove the optical drive connector board:
100 Chapter 4 Removal and replacement procedures
Battery on page
Hard drive on page
Optical drive on page
Keyboard on page
Switch cover on page
Fan on page 67)
Heat sink on page
Display assembly on page
Top cover on page
ExpressCard board on page
Audio board on page
Speaker on page
Rear cover on page
SIM connector board on page
System board on page
46).
52)
55)
60)
65)
68)
74)
80)
83)
84)
87)
91)
96)
Spare part number
487121-001
93)