Kenwood NX-1200A User Manual page 82

Semi-VOX Operation
1
Connect a headset to the transceiver.
• The VOX function does not activate when a headset is not connected to
the accessory terminal of the transceiver.
2 Press the button programmed as [VOX Function].
Alternatively, you can press the button programmed as [Menu] to enter
•
VOX Mode using the Menu Mode.
• Beep A (1 beep) sounds and the "
3 To transmit, press the PTT switch.
4 Release the PTT switch.
5 Transmission continues while speaking.
6 When you finish speaking, transmission ends.
To turn the Semi-VOX function OFF, press the button programmed as [VOX
Function] button again.
• Beep B (2 beeps) sounds and the "
display.
VOX Gain Level
Sets the Microphone input sensitivity of the VOX operation.
1
Connect a headset to the transceiver.
2 Press the button programmed as [VOX].
• The current VOX Gain level appears on the display.
3 Press the [ <B ] or [ C> ] button to increase or decrease the VOX Gain level.
• The VOX Gain can be adjusted from levels 1 to 10.
4
While adjusting the level, speak into the headset microphone to test the
sensitivity level. (Your voice is not transmitted during this test procedure.)
• When sound is recognized, the LED lights yellow.
5 Press the [ S ] button to save your new setting.
" indicator appears on the display.
" indicator will disappear from the
82