Kenwood NX-1200A User Manual page 65

Keypad Auto PTT
Status
Short Message
Individual
Individual +
Status
Individual + Short
Message
Group
Group + Status
Group + Short
Message
This function allows you to send DTMF by pressing Keypad
without PTT switch.
• If DTMF Manual Dialing is Enabled, the DTMF Code is
sent by pressing the [ 0 ] ~ [ 9 ], [
Press the [ 0 ] ~ [ 9 ], [
•
Code of the pressed button.
• When the button is release, the modulation of DTMF
Code will stop, but unmodulated transmission will
continue for the time set by DTMF Hold Time.
Press the [ 0 ] ~ [ 9 ] button to enter the Status Mode and
keypad input state.
Press the [ 0 ] ~ [ 9 ] button to enter the Short Message
Mode and keypad input state.
Press the [ 0 ] ~ [ 9 ] button to enter the Individual Call
Mode or Selcall Mode and keypad input state.
Press the [ 0 ] ~ [ 9 ] button to enter the Individual Call
Mode or Selcall Mode and keypad input state.
Similar to pressing the PF button for [Individual +
•
Status], press the [ S ] button in Individual Call Mode to
enter the Status Mode.
Press the [ 0 ] ~ [ 9 ] button to enter the Individual Call
Mode or Selcall Mode and keypad input state.
• Similar to pressing the PF button for [Individual + Short
Message], press the [ S ] button in Individual Call Mode
to enter the Short Message Mode.
Press the [ 0 ] ~ [ 9 ] button to enter the Group Call Mode or
Selcall Mode and keypad input state.
Press the [ 0 ] ~ [ 9 ] button to enter the Group Call Mode or
Selcall Mode and keypad input state.
• Similar to pressing the PF button for [Group + Status],
press the [ S ] button in Group Call Mode to enter the
Status Mode.
Press the [ 0 ] ~ [ 9 ] button to enter the Group Call Mode or
Selcall Mode and keypad input state.
Similar to pressing the PF button for [Group + Short
•
Message], press the [ S ] button in Group Call Mode to
enter the Short Message Mode.
], [ # ] button, send the DTMF
65
], [ # ] button.