Kyocera Triumph-Adler 302ci Operation Manual page 149

Fax Settings > Default fax settings
Item
Remote SW Dial
Encrypted Reception
ECM RX
RX Start Speed
TX/RX Restriction
This function allows you to send or receive originals only when communication requirements are met.
Transmission Restriction (page 8-11)
Forward Settings
When you have received a fax, you can forward the received image to other faxes and computers or specify a number of
copies.
Forward Settings (page 5-2)
New Destination Entry (FAX)
Item
New Destination Entry (FAX)
To start fax reception by operation from the connected telephone set, use the following operation.
Value: 00 - 99
Remote Switch Function (page 5-36)
Turns on reception by encrypted communication.
Value: Off, On
If turned on, select the encryption key.
Encryption (page 5-23)
Set whether ECM RX is performed.
ECM is a communication mode specified by the ITU-T (International Telecommunication Union)
that retransmits data when an error occurs. Fax machines that have ECM mode check for
errors as they communicate, preventing distortion of the image due to noise on the line and
other conditions.
Value: On, Off
NOTE
When there is a large amount of noise on the line, communication may take slightly longer than
when [Off] is selected.
Change the RX Start Speed.
When communication conditions are bad, the fax may not be received correctly. In that case,
set a lower RX Start Speed.
Value: 9600bps, 14400bps, 33600bps
NOTE
Normally this should be used with the default setting.
Select whether to permit direct entry of destination. When this option is set to [Prohibit],
you cannot enter the destination directly.
Value: Permit, Prohibit
8-10
Description
Description