Chapter 49: Removing The Logo Board; Prerequisites; Procedure - Dell Alienware Area-51 Service Manual

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•

Prerequisites

•

Procedure

Prerequisites
1. Remove the stability foot.
2. Remove both the left and right side-panels. See
3. Remove the memory fan.
Procedure
NOTE: Note the routing of all cables as you remove them so that you can route them correctly after you replace the logo
board.
1. Lay the chassis on the right side.
2. Disconnect all the cables from the logo board.
3. Remove the screw (#6-32x6) that secures the logo board to the chassis.
4. Slide the logo board out of the chassis.
Figure 31. Removing the logo board
a. logo board
Removing the logo board
computer. After working inside your computer, follow the instructions in
"Removing the Side Panels".
Removing the logo board
49
After
www.dell.com/
87