Table of Contents
Advertisement
ZN 0 1
BA CK
DO O R
ÊÊÊ
+
Flashing Cursor if Ò6Ó is
pressed (system ready for
next word).
Summary Display
ZN 0 1
BA CK
DO O R
P r o g r a m A lph a ?
0 = No , 1 = Ye s
0 0
A lph a P g m
8 2
–68–
Ê9. Press Ò6Ó to accept the selected
ÊÊword.
ÊNOTE: If these are the only words
you ÊÊare using for the descriptor,
press Ò8 Ó ÊÊinstead of Ò6 Ó to save them
in ÊÊmemory.
10. The two words in our example have
now been entered. Note, however,
that up to three words may be
entered (provided the number of
characters will fit on the screen).
Press Ò8Ó to save all words in
memory.
The flashing cursor will disappear,
indicating that the word(s) are stored
in memory for that zone, as shown in
the summary display at the left.
11. To enter a descriptor for the next
zone, press
plus the desired zone
number (e.g.,
display following step 4 previously
will appear. Now repeat steps 6
through 10 for the descriptor for the
next zone.
12. To exit the Alpha descriptor mode,
press Ò +0+0Ó at the summary
display.
This prompt will be displayed.
13.
Press Ò0Ó. This will be displayed.
14. Press
99 to exit the programming
mode.
02. The summary
Advertisement
Table of Contents
