Installation And Setup Of The 5881/5882 Receiver; Figure 12.Êê5881/5882 Rf Receiver (Cover Removed) - First Alert FA162C Installation Instructions Manual

Installation and Setup of the 5881/5882 Receiver

ON OFF
NOTE: CIRCUIT BOARD IS MOUNTED IN
CONTROL'S CABINET, GROUNDING LUGS (2)
PROVIDED MUST BE INSERTED IN LEFT-
HAND TERMINALS OF ANTENNA BLOCKS AND
SECURED TO CABINET (SEE RECEIVER'S
AND CONTROL'S INSTRUCTIONS)
MOUNTING
HOLES
TO RELEASE CIRCUIT BOARD,
REMOVE SCREWS (2)
AND BEND BACK TABS (2).
1. Set the receiver's DIP switch for device address Ò0Ó, as described in its
instructions (all switches to the right. . . ÒoffÓ).
=
2. Mount the receiver. The RF receiver can detect signals from transmitters
within a nominal range of 200 feet. Take this into consideration when
determining mounting location.
3. Connect the receiver's wire harness to the control's keypad terminals (4,
5, 6, and 7). Plug the connector at the other end of the harness into the
receiver.
4. Refer to the installation instructions provided with the receiver for
further installation procedures regarding antenna mounting, etc.
CIRCUIT
BOARD
INTERFERENCE
INDICATOR
LED
Figure 12. 5881/5882 RF Receiver (cover removed)
ANTENNAS
INSERT IN
RIGHT-HAND
TERMINALS
@ @ @ @ @ @ @ @ e ? @ @ @ @ @ @ @ @ e ? @ @ @ @ @ @ @ @ ? e @ @ @ @ @ @ @ @ e ? @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ e ? @ @ @ @ @ @ @ @ ? e @ @ @ @ @ @ @ @ e ?
@ @ h ? @ @ @ @ @ @ @ @ e ? @ @ h ? @ @ @ @ @ @ @ @ @ @ @ @
@ @ h ? @ @ h ? @ @ @ @
@ @ h ? @ @ h ? @ @ @ @ 5882
@ @ @ @ @ @ @ @
@ @ @ @
@ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @
@ @ @ @
@ @ @ @ @ @ @ @ @ @ @ @
@ @ @ @ @ @ @ @ @ @ @ @
@ @ @ @ @ @ @ @
@ @ @ @ @ @ @ @
@ @ @ @ @ @ @ @
@ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @
@ @ @ @ @ @ @ @ LOCATION
@ @ @ @ @ @ @ @
@ @ @ @ @ @ @ @
@ @ @ @ @ @ @ @
@ @ g @ @ g @ @ g ? @ @ ? @ @ ? @ @
@ @ g @ @ g @ @ g ? @ @ ? @ @ ? @ @
@ @ @ @ @ @ @ @ @ @ @ @ @ @ @ @ ? @ @ @ @ @ @ @ @ ? e @ @ @ @ @ @ @ @ e ? @ @ @ @ @ @ @ @ ? @ @ @ @ @ @ @ @ ? e @ @ @ @ @ @ @ @ e ? @ @ @ @ @ @ @ @ ? @ @ @ @ @ @ @ @ ? @ @ @ @ @ @ @ @
PLUG
&
SOCKET
DIP SWITCH
–24–
MODEL No. IS INDICATED
ON CIRCUIT BOARD
YELLOW
}
RED
TO CONTROL'S
BLACK
REMOTE KEYPAD
GREEN
CONNECTION
POINTS.
WIRING
OPENING
KNOCKOUT
AREA FOR
SURFACE
WIRING