Table of Contents
Advertisement
Summary Mode Display
[
Default DescriptorÊ
ZN 0 1
ZO NE 0 1
Flashing Cursor (system is
ready for entry of word).
[
ZN 0 1 ÊÊÊ
[
Flashing Cursor
ZN 0 1
B A CK
ZN 0 1
BA CK
ÊÊÊ
+
Flashing Cursor if Ò6Ó is
pressed
(system is ready
for next word).
ZN 0 1
BA CK
D O O R
+
Flashing Cursor
–67–
If a descriptor was not entered
previously for zone 1, the default
descriptor for zone 1 will be
displayed.
Note that this a Òsummary modeÓ,
and that no entries can be made.
Entries can be made only when the
display contains a flashing cursor,
which signifies the Òentry modeÓ.
5. To delete or change the default
descriptor for zone 1, press
the same zone number (01). This
will clear that descriptor and allow
changes to be made at the flashing
cursor.
NOTE: If you do not wish to change
the existing descriptor for zone 1,
enter [ ] plus the next zone number
for which you wish to enter (or check)
a descriptor. A summary display for
that zone will appear. You must then
press [ ] plus the same zone number
again to gain access to the entry mode
(flashing cursor) for that zone.
6. Press [#] plus 3-digit number for
the first word from the ÒAlpha
Vocabulary ListÓ. Example: The
descriptor that we wish to enter for
zone 1 is BACK DOOR. From the list,
BACK = 013. Therefore, you would
enter # 0 1 3 .
Note:ÊÊIf you accidentally enter the
wrong word, simply press [#] plus the
correct 3-digit number for the word
you want.
7. Press Ò6Ó to accept the selected
word and continue.
NOTE:
If this is the only word you
are using for the descriptor, press Ò8Ó
instead of Ò6 Ó to save that word in
memory, and then go to step 11.
8. Enter the 3-digit number for the
next word. In our example, the word
is DOOR, whose number is Ò057Ó.
Enter # 0 5 7. This display will
appear:
plus
Advertisement
Table of Contents
